Home › New York › White Plains

Boiler Repair in White Plains, NY

In White Plains, 25% of households heat with oil and 59% with gas — enough of each that neither is an assumption anybody should make about your house without looking.

In brief

A town that splits its heating has both trades in it. White Plains does, at 25% of households on oil and 59% on gas, so knowing which appliance is in the basement before telephoning saves the wrong one turning up.

Source: US Census Bureau, American Community Survey 5-year estimates, table B25040.

BoilerBridge is a referral service, not a contractor. We connect homeowners with independent contractors. Contractors are required to hold whatever credential their state or municipality demands. Every state page sets out who licenses plumbers there and where to check, so you can confirm before work begins. We carry out no work, we sell no equipment, we do not set prices, and we never charge homeowners anything — the contractors in our network pay us when we route them a call.

How White Plains heats

Where neither fuel dominates, nobody assumes anything about your house, which is an advantage. Say which fuel and whether it is hot water or steam when you call, and the first visit starts further along.

Households in White Plains	Share
Fuel oil and kerosene	25%
Gas — mains and bottled	59%
Electricity	14%
Wood, coal, solar or no fuel	2%

Across the 159 towns we cover in New York, 17% of households heat with oil. White Plains sits about level with that.

Source: US Census Bureau, American Community Survey 5-year estimates, table B25040 (house heating fuel), 2023 release. Universe: 29,167 occupied housing units. The Census asks what the house is heated with, not what equipment does the heating. The oil share above therefore includes furnaces as well as boilers.

Carbon monoxide

"Have the heating system professionally inspected and serviced annually to ensure proper operation" is CPSC’s wording, and it is a safety recommendation about combustion and venting rather than an efficiency suggestion.

Source: US Consumer Product Safety Commission, Carbon Monoxide Fact Sheet.

Hot water or steam

Knowing whether the system is hot water or steam saves a visit. A steam boiler has a sight glass and a low water cutoff; a hot water boiler has a circulator, an expansion tank and a pressure gauge worth reading. Almost nothing that is true of one is true of the other.

DOE regulates them separately too, at slightly different AFUE minimums by fuel and type.

Source: US Department of Energy, Energy Conservation Standards for Residential Boilers.

What to ask whoever comes

Ask what the combustion readings were and whether they changed since last year. One set of numbers is a snapshot; two are a trend, and a trend is what shows something drifting before it fails.

Other New York towns we route in

South Salem 67% heat with oil
East Greenbush 14% heat with oil
Holbrook 54% heat with oil
Central Square 10% heat with oil
Hastings On Hudson 23% heat with oil

Everywhere we route in New York

Checking a plumber in New York

New York issues no state plumbing license. New York City licenses Master and Journeyman Plumbers through the Department of Buildings; elsewhere in the state it is your own city, town or county. Start here. Ask the contractor which municipality licenses them and confirm it with that office before work begins.

A boiler is not a furnace, and the person you want knows the difference.Tell us it is a boiler, tell us what the gauge reads if you can see it, and we will route you to somebody in your area who works on them. You are never charged. Should other work in White Plains need doing, say it on the call.

Call (888) 510-4130